1.
Turn power off. 2. Raise needle to its highest position by
rotating the hand wheel towards you. 3. Raise presser foot.
4a.Horizontal threading - place spool of thread
on spool pin and slide spool pin holder/cap firmly over rim
of spool to prevent thread from tangling.
4b.Vertical threading - raise spool pin and place
felt and thread onto spool pin.
5.
Lead thread passing it first through the lower slot on the
underside of the thread guide. Next through the upper slot,
leading the thread over and around to the right. Pull thread
into thread guide.
6a. Pass the thread
through the second thread guide by leading the thread to the
right and under the guide, inserting it from the bottom over
the top.
6b. Holding thread
ends in each hand snap thread into upper thread guide.
7a. Lead the thread
down and around the tension mechanism. Hold the spool with your
right hand lightly and pull the thread up with your left hand
allowing the thread to slip into the tension discs.
7b.
Following arrows, guide thread down into threading channel making
sure the thread is inserted in the tension discs (2).
8.
Thread take-up lever eye. (Take-up lever is slotted for easier
threading). Pull down 6"-8" of thread.
9.
Pull thread through thread guide(s) above the needle.
Cart
