| Recommended Settings: |
Stitch Selection:
Buttonhole Stitch
Stitch Width: 
Stitch Length: 4"
Presser Foot: Buttonhole Foot |
| Fastening Buttonholing Presser Foot |
 |
1. Remove presser foot from
shank. |
 |
2. Center pin (1) in presser
foot under shank. |
 |
3. Press presser foot screw
down firmly until shank snaps into place. |
| Setting Length of Buttonhole |
 |
4. Pull buttonhole lever
(2) straight down as far as it will go.
5. Press it toward you.
6. Place button against lever (2) and slide clamp (3)
back until it touches. |
 |
7. Center red guidelines
(4) of foot around beginning line.
8. Lower presser foot. |
 |
9. Start running machine.
10. The entire buttonhole will be sewn in one operation.
11. Stop sewing when leg begins overlapping bartack. |
 |
12. Raise presser foot.
13. Remove fabric from machine. |
 |
14. Clip threads end; cut
buttonhole opening with scissors or seam ripper.
15. Push buttonhole lever (2) back up into machine. |
| Adjusting Balance of Buttonhole |
 |
16. If two stitching sides
of a buttonhole are unequal, move stitch balance lever
to adjust.
17. If right side is too open, move stitch balance
lever slightly to right.
18. If left side is too open, move stitch balance lever
slightly to left.
|
