Winding a bobbin is quick and easy when you follow the directions
below. Always wind the bobbin before threading the machine
and needle.
1. Place spool of
thread on spool pin.
2. Slide spool pin holder/cap firmly over rim of spool to
prevent thread from tangling.
3. Push bobbin winder pin to
far left if it is not already there.
4. Pass the thread from spool through thread guide as shown
(illustration 1).
5. Pass thread end, from inside, through small hole in rim
of bobbin (illustration 2).
6. Place bobbin onto pin.
7. Push bobbin winder pin to the right (illustration 3).
This will stop the needle from moving.
8. Holding thread
end, step on speed controller to run machine until desired
amount of thread is wound. (Winding stops automatically once
bobbin is full.)
9. Cut thread; push bobbin to the left and remove it from
bobbin winder pin (illustration 4).
Cart
