Inserting Bobbin - Top Drop-In

Back to Operation Basics

  • Raise presser foot.
  • Turn hand wheel toward you until needle is in its highest position.
  • Open slide plate and remove empty bobbin

1. Pull 4" (10 cm) of thread from replacement bobbin and insert bobbin into case, as shown.
2. Holding bobbin in place, guide thread into notch (1) and then down the slot to the left and guide into notch (2).
3. Draw several inches of thread diagonally across bobbin toward the back of the machine.
4. While holding thread on outside, close the slide plate allowing thread to extend through the slot between the slide plate and needle plate.